Lithium Batteries

Product Details:

PLC Lithium Batteries is offering by us to the clients. The PLC Lithium Batteries we offer is shock resistant and is known for its corrosion resistant. These batteries perform reliable operations and they have smooth functioning. Offered batteries are technically advanced and are user friendly in nature.

Product Details:

• Used in potentially explosive atmospheres
• Enhanced capacity
• High voltage response, stable during most of the lifetime of the application
• Wide operating temperature range (- 60°C/+ 85°C)
• Low self-discharge rate (less than 1 % after 1 year of storage at + 20°C) Key features
• Non-flammable electrolyte
• Compliant with IEC 60079-11 intrinsic safety standard and IEC 60086-4 safety standard
• Stainless steel container and end caps (low magnetic signature)
• Hermetic glass-to-metal sealing

• Non-restricted for transport
• Manufactured in UK and China

• Gas metering
• Automatic meter reading
• Alarms and security devices
• Miners cap lamps
• Gas detectors
• Air monitoring equipment
• Safety torches
• Gas tanks level monitoring
• Miner equipment

• The storage area should be clean, cool (preferably not exceeding +30°C), dry and ventilated. Warning
• Fire, explosion and burn hazard.
• Do not recharge, short circuit, crush, disassemble, heat above 100°C (212°F), incinerate, or expose contents to water.
• Do not solder directly to the cell (use tabbed cell versions instead).

Electrical characteristics

• (typical values relative to cells stored for one year or less at +30°C max.) Nominal capacity 2.6 Ah (at 2 mA +20°C 2.0 V cut-off. The capacity restored by the cell varies according to current drain, temperature and cut-off)
• Pulse capability: Typically up to 250 mA (250 mA/0.1 second pulses, drained every 2 mn at +20°C from undischarged cells with 10 µA base current, yield voltage readings above 3.0 V. The readings may vary according to the pulse characteristics, the temperature, and the cell’s previous history. Fitting the cell with a capacitor may be recommended in severe conditions. Consult Saft)
• Maximum recommended continuous current 50 mA (Higher currents possible, consult Saft)
• Operating temperature range -60°C/+85°C (Operation above ambient T may lead to reduced capacity and (-76°F/+185°F) lower voltage readings at the beginning of pulses. Consult Saft)

Physical characteristics

• Available termination suffix CN, CNR radial tabs 2 PF, 3 PF, 3 PF RP, 4 PF radial pins CNA (AX) axial leads FL flying leads...etc.

IEC 60079-11 Intrinsic safety characteristics

• (T4 up to +55°C) I short-circuit current (max) 3.7 A
• Ri (max) 989 m Ohm